#CAR TINTED WINDOW INSTALL#
#CAR TINTED WINDOW DRIVERS#
#CAR TINTED WINDOW PROFESSIONAL#
#CAR TINTED WINDOW WINDOWS#

If the damage is too severe and you have decided the best course of action is to remove the tinting completely and start over, follow these directions to completely remove the tinting.

Tip: Use the straightedge to remove any air bubbles that have formed.

As you hold the new tinting in place, pull out the sections of the old tint that have been cut and press the new tint into place it should fit in correctly. Repeat this process on the other three sides. Use a straightedge to guide your razor blade to cut through both the old and new tinting where it overlaps on the edges of the square you cut out. Step 10: Cut through old and new tinting. Apply the new tinting per the manufacturer's instructions, pressing the film onto the glass and clearing any bubbles that form. Wet the window using the spray bottle with distilled water. You should cut out a section of new tinting film that is roughly 1 inch larger on all sides than the square. Step 7: Cut a section of new tinting film. Clean the section where the tinting has been removed, making sure to get all of the remaining glue or adhesive off of the window. Remove the cutout section, using the razor blade to loosen any difficult sections. Use a spray bottle to apply a fine mist of distilled water to the section to be removed.

Note: Window tinting sheets have two layers so be sure your razor blade goes through both down to the glass.

Carefully lift a corner of the tinting of the cutout section, being careful to not rip or tear the undamaged tinting on the window. Step 2: Cut the peeling area: Use a razor blade to cut the perimeter of your marked area. Be sure it includes all of the peeling area. Carefully mark out a square around the damaged and peeling tinting.

#CAR TINTED WINDOW INSTALL#

Repairing peeling tint is a little more complicated as you will need to remove the peeling section and install a new section of tinting. Warning: Be careful not to rip or tear the tinting as you are using the safety pin or smoothing with the credit card. Note: If the tinting dries before you pop them all, re-apply a fine misting of water. Hold it at a 45-degree angle and use long strokes with medium pressure to smooth out any remaining bubbles. Smooth out the tinting using a straight edge or credit card. The tint should close up the tiny hole after the air has escaped. Pop the air bubbles with a safety pin, making very tiny holes and taking care to not rip or tear the tinting. Use a credit card or other straight edge device to push the air bubbles to the edge of the tinting which will release the air. There are a couple of different ways to remove air bubbles: The cold water interacting with the hot window will loosen the adhesive, making it easier to get the air bubbles out. Once the window is heated up, use a spray bottle to apply a fine mist of water to the window tint. Tip: If you can’t wait for a sunny day, a hair dryer will also do the job. Tip: Let the car sit outside for a couple of hours in the sun before starting your work. Window tinting is easier to work with and the adhesive is more pliable when it is a sunny day and the temperature is at least 75 degrees. If you applied the tint yourself or it is out of warranty, decide if you want to repair it yourself or hire a professional.

#CAR TINTED WINDOW PROFESSIONAL#

Step 1: Check on the warranty: If you paid a professional to apply the tinting and it is still under warranty, call them and ask for it to be repaired or replaced entirely.

Warning: There are state and city ordinances that pertain to tinting so make sure you are within the laws before applying or repairing a window tint.įollow these instructions to fix the most common issues with window tinting.

It is possible to repair a bad tint job yourself, if necessary. It can peel, or bubble, which not only looks awful but also prevents it from doing its job. Window tinting can go bad if not properly applied. In most cases, using a professional is the best option, but, unfortunately, not every professional is as skilled as he or she should be, which can lead to a sub-par tinting job that needs to be fixed. Window tinting can be a do-it-yourself project, but it requires serious attention to detail and patience. Thicknesses range from 0.001 to 0.004 inches and there are a number of different adhesives to apply the tinting to the windows. Tinting comes in a variety of thicknesses and degree of tinting.

#CAR TINTED WINDOW WINDOWS#

A transparent, very thin sheet of film is applied to the windows of a vehicle. Window tinting is a pretty simple process.

#CAR TINTED WINDOW DRIVERS#

Tinted windows on a car are a great way to improve its look, and they help keep both the sun and the prying eyes of other drivers and potential thieves out of your vehicle.

Car tinted window